24
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the front
bottom corners of the cooker.
Unfold the rear edge of pack base tray. Carefully push the
cooker backwards along the hardboard strips and into
position. Take care not to damage the power cable. Push
the cooker close to its final position, leaving just enough
space to get behind it.
Conversion to LP
If the appliance is to be converted to LP gas do the
conversion at this point. See the conversion section of
these instructions.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise to
lower.
When you are satisfied with the height and level raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the floor. Screw the
front roller adjuster anticlockwise to raise the front roller
so that the front of the cooker is supported on the feet,
not the front roller, to prevent accidental movement of
the cooker.
Gas Connection
Fitting a stability bracket
A stability bracket or chain (not supplied by with the
cooker) should be fitted when the cooker is connected
to a flexible gas supply. Any restraining device should be
secured to the fabric of the building and should be able
to be released so that the cooker can be pulled out for
cleaning and maintenance.
When fitting a stability bracket, read these instructions
together with the leaflet supplied with the bracket.
a) Position and level the appliance.
b) Draw a pencil line 68mm from the front edge of the
levelling feet.
c) Mark off 300mm from the RH side of the unit to
indicate the centre line for the bracket.
d) Remove the unit.
e) Mark off 595mm to locate the front edge of the lower
bracket. Fix bracket to floor.
f) Measure the height from floor level to the top edge
of the rear channel. Add 3mm to this dimension and
assemble the stability bracket to this height (i.e. from
floor level to underside of top member)
Connecting the Supply
The Gas supply needs to terminate with a down facing
bayonet. The rear cover boxes limit the position of the
supply point.
