8.
Once all the Velcro is in place the last thing to do is install the screw snap studs. NOTE:
The best way
to install the snap studs is to put them in the sockets in the door first. Then push them into the
plastic to make a mark. Then pull the screw stud out and screw it into the plastic where the mark
was made. See Photo Below.
9.
Final step on the doors are to install the polycarbonate panel in the hole at the bottom of the factory half
door. Take the panel screws and install the panel on the inside of the door as shown in the pictures
below.
Cleaning and Storage Recommendations:
1.
Before removing the Cab for storage, make sure it is very clean in order to prevent scratching of the
window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water
solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting
to roll for storage.
2.
It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to
the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory.
On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and
windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter.
Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose
the Cab to either extreme hot or cold temperatures when storing.
3.
A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of
the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Thank you for your purchase!
