6.
Next pull the front of the cab down on see where the 48” adhesive Velcro will go along the top of the
windshield. Place the adhesive strip on the windshield and attach the cab to it.
7.
Note the position and install four 8” Velcro tabs on the left and right side of the roll cage for the front
window. Then place the 3” adhesive strips on the inside of the frame where the double-sided strips are
sewn to the bottom of the front wing. Be certain to clean the surfaces before applying the adhesive hook
strips! First, apply all three strips on one side of the roll cage and attach the unit.
8.
Finally attach the two 10” adhesive strips down the sides of the rear window.
Cleaning and Storage Recommendations:
1.
Before removing the Cab for storage, make sure it is very clean in order to prevent scratching of the
window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water
solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting
to roll for storage.
2.
It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to
the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory.
On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and
windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter.
Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose
the Cab to either extreme hot or cold temperatures when storing.
3.
A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of
the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Thank you for your purchase!
