2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of
Club Car 1550 Mini Cab Enclosure with Lexan Windshield
CC-1550-MC02
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
Be sure to read these instructions thoroughly before opening and installing. The installation is best done
when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions
prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to
installation.
1.
Carefully open the carton and remove the rolled up Cab Enclosure on a large flat surface that is clean
and free of dirt or other material that may soil or scratch the windows of the Cab.
2.
It will help to unhook the hood prior to installing the cab enclosure
3.
Check over the parts included in the carton with the parts list shown below:
Velcro Hook strips: 4 each
3” long
“ “
4 each
8” long
“ “
2 each
10” long
“
“
1 each
32” long
“
“
1 each
48” long
Cab Enclosure
1 each
If any parts are damaged or missing please contact customer service at (606) 845-7439.
4.
Begin by installing the windshield as described in the instruction included with it. After installing the
windshield drape the enclosure over the top of the vehicle and center it on the roll cage.
5.
Next raise the bed and place the 32” adhesive Velcro strip across the bottom rear of the cab, align with
Velcro on rear of cab. Now pull down on the rear of the cab enclosure and affix to the Velcro. See
Photo at top of next page:
