2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of CF Moto U Force
Aero-Vent Lexan Windshield
CF-UFORCE-WD05 / 50-40067
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are
happy with the product before removing protective film. Once the film is removed you cannot return the product
for a full refund.
Be sure to read these instructions thoroughly before opening and installing the CF Moto U Force Aero-Vent
Lexan Windshield.
1.
Check over the parts included in the cartons with the parts list shown below:
Strap Clamps
4 each
1” Stainless Steels Bolts
2 each
Stainless Steel Washers
2 each
Plastic Thumb Nuts
2 each
Slide Fasteners
8 each
52” Rubber Gasket
1 each
Lexan Vent Slider
2 each
Lexan Windshield
1 each
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2.
Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by
peeling off the protective film. Next take the 52” piece of rubber gasket and starting at one end firmly
place across the bottom of the windshield. You may need to trim off excess gasket. The diagram below
show where to install the gasket.
