Note
Do not fit oven fan from one motor on to another or
imbalance forces may result and thus cause vibration
and excessive noise. When fittingfan to shaft ensure
that pin in shaft is engaged in its mating slot in fan
boss.
3.18 OVEN LIGHTS (G7204 and G7208 only)
a) Carry out operations as Section 3.17a),b) and (c).
b) Pull or gently prise off glass lens and plated bezel
from rear panel of oven chamber.
c) Remove bulb.
d) Fit new bulb and replace glass lens and bezel by
pushingin until the springclips are located. Ensure
that flexible washer is in place between bezel and
oven rear panel.
e) Replace in reverse order.
Note
The correct type of bulb MUST be used i.e. an E 14
thread, 240V heat resistant type.
3.19 CAPACITOR
a) Undo fixings and remove outer back panel.
b) Disconnect two capacitor leads at motor terminal
block.
c) Undo fixingnut on capacitor base and remove unit.
d) Replace in reverse order.
Figure 1
3.20 OVEN DOOR SEAL REPLACEMENT
Seal is fitted to front frame using countersunk
screws.
When fittingnew seal, place metal strip in position,
pierce holes in seal and secure to holes in front
frame.
3.21 DOOR REMOVAL
a) Remove bottom front panel as Section 3.2.1.
b) Open doors through 90
o
and remove fixings which
secure door to bracket.
c) Slightly lift door vertically and ease to the side to
clear bottom bracket. Withdraw from top hinge pin.
d) Replace in reverse order.
3.22 DOOR CATCH MECHANISM
a) Open doors and remove fixings at front and rear
which secure top panel. Withdraw top panel by
liftingup at rear to clear flue outlet cover and slide
forward. Twist rear slightly to one side to clear
locatingangles at front sides of top panel.
b) Unhook spring. Remove nut and split pins from top
of toggle plate pins.
c) Replace new component(s) and re-assemble as
indicated in Figure 1.
d) Replace top panel.
