A
B
C
3
1
2
A pressure test point is provided on burner inlet
supply, accessible when facia panel is removed.
1.10 BURNER ADJUSTMENT
The burner has a fixed air inlet and gas injector.
NO ADJUSTMENT IS REQUIRED.
The pressure must be checked as detailed in
Section 1.9.
SECTION 2 - ASSEMBLY and
COMMISSIONING
2.1 ASSEMBLY
The oven is normally a basic freestanding unit and
when specified, a separate package of suite-ing
components are supplied. Assemble these
components as follows while referring to Figure 1.
1. Remove rear bottom screws (C) from each side.
2. Loosen cistern fixing screws (B) by approximately
three turns. Insert flange of each side extension
panel (3) behind cistern flanges until slots engage
around loose screws (B). Tighten screws (B) and
replace rear bottom screws (C) to secure side
extension panels.
3. Remove screws (A), position rear cover panel (1)
against unit rear. Replace screws (A) to secure
whilst pushing upwards to close against top panel.
4. Position rear extension panel (2) over side
extensions (3) and against rear cover panel (1).
Use screws provided to secure (2) to (1) and (3).
For all units, continue assembly as follows:-
5. Position unit and level. A levelling bolt is provided
in each foot with facility for floor fixing if required.
SUITING ASSEMBLY
6. Ensure all packing material is removed from oven
and cistern. Check also that steam vent is clear.
7. Hang shelf runners inside compartment and insert
trays or baskets.
2.2 CONNECTION TO GAS SUPPLY
The gas supply piping and connection to appliance
must be installed in accordance with the various
regulations listed on the cover of this manual.
On NATURAL GAS appliances, an adjustable
governor MUST be fitted in the supply. It is situated
behind the lower door. On appliances burning
PROPANE, a governor must NOT be fitted.
2.3 CONNECTION TO WATER SUPPLY
1. Connect water services including overflow from
cistern.
2. Turn on water, allow cistern to fill and check that
water depth within the compartment is correct
(70mm). Adjust ball arm valve if necessary.
Figure 1
All manuals and user guides at all-guides.com
