FALCOM MAMBOII, User Manual

Page: 162 / 271

C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
- V
ERSION
1.0.0
1
Starts an animation as screen saver .
2
Starts an LED blinking as screen saver.
<timeout>
Specifies how much time, in seconds, must elapse before the screen saver is
launched. It can be set from a minimum of 1 second to a maximum of 86400
seconds (24 hours). If set to zero, the screen saver does not launch.
How to set/get display configuration:
Set configuration
$PFAL,Cnf.Set,DISP.SAVER=3
Get configuration
$PFAL,Cnf.Get,DISP.SAVER
3.2.11.8 DISP.TZ
Parameter syntax DISP.TZ= <tnz><hh> . <mm>
The parameter is used to convert from time-zone name to local time and show it
when screen saver is activated. To convert time-zone value to your local time, it is
necessary to know the difference between them.
<tnz>
Three-letter time-zone name, such as UTC.
Value Meaning
UTC
Coordinated Universal Time - the international basis for
other time zones. Time zones around the world are
expressed as positive or negative offsets from UTC.
GMT
Greenwich Mean Time . It is now often used to refer to
Coordinated Universal Time (UTC) when this is viewed as a
time zone, although strictly UTC is an atomic time scale
which only approximates GMT in the old sense.
CET
Central European Time
is one of the names of the time
zone that is 1 hour ahead of Coordinated Universal Time
(UTC). It is used in most European and some North African
countries. Its time offset is UTC+1.
MEZ
Central European Time (Mitteleuropäische Zeit, MEZ;
UTC+1)
<hh>
Specifies difference in hours between the specified time zone name and local
time. Time zones around the world are expressed as positive or negative offsets
from UTC.
For example , local time in Frankfurt (Germany) is 2 hours ahead of UTC. While
local time in Los Angeles (USA) is 7 hours behind UTC. Therefore, to display the
time in Frankfurt (Germany) you have to enter
+2.0
to the time zone UTC while in
Los Angeles (USA) enter
-7.0
.
<mm>
Specifies minutes. Separated from <hh> by a dot ( . ).
How to set/get display configuration:
Set configuration
$PFAL,Cnf.Set,DISP.TZ=UTC+2.0 //for Germany
$PFAL,Cnf.Set,DISP.TZ=UTC-7.0 //for Los Angeles (USA)
Get configuration
$PFAL,Cnf.Get,DISP.TZ
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 162 of 271