C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
-
V
ERSION
1.0.0
3.2.5.4.3
GSM.DataCall.Hangup – Hangs up an active voice call
Command syntax
$PFAL,GSM.DataCall.Hangup
Examples
$PFAL,GSM.DataCall.Hangup
Responses
Command description
This command rejects an incoming data call or it finishes an established data call.
Parameter Description
None
3.2.5.5
“GPRS” command index
3.2.5.5.1
GSM.GPRS.Connect – Performs a GPRS attach
Command syntax
$PFAL,GSM.GPRS.Connect
Examples
$PFAL,GSM.GPRS.Connect
Responses
Command description
This command attaches the MAMBOII to the GPRS services. If the MAMBOII is not
able to attach for more than 5 minutes, no message is returned, but MAMBOII is still
trying to attach. The runtime routine can be seen on a terminal program, if device
debugging mode is switched on or you can configure a LED indicator to indicate
whether the MAMBOII results GPRS attached or detached–see examples in
chapter
Parameter description
none.
Notes
•
If a GPRS attach is initiated and the MAMBOII is not able to attach, it starts
with the default value, due to missing values of the
GPRS.APN
,
GPRS.QOS
,
GPRS.QOSMIN
,
PPP.USERNAME
and
PPP.PASSWORD
parameters
according to the used SIM card.
3.2.5.5.2
GSM.GPRS.Disconnect – Performs a GPRS detach
Command syntax
$PFAL,GSM.GPRS.Disconnect
Examples
$PFAL,GSM.GPRS.Disconnect
Responses
E.g.
$perform GPRS disconnection
$SUCCESS
Command description
This command is used to detach the MAMBOII from the GPRS services. Any active
PDP contexts will be automatically deactivated when the attachment state
changes to detached. If the MAMBOII is not able to detach for more than 1 minute,
no message is returned, but MAMBOII is still trying to detach. If an attachment is
issued during a running detach that message is ignored.
Parameter description
none.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 109 of 271
