Technical specifications
Inputs: 1k
Ω
0.1% input impedance, ±10V max input voltage; single-ended BNC and
differential connector
Outputs: ±5V maximum output voltage (differential ±10V), short-circuit proof
Gain: buffered out: +1x, inverted out: -1x. The single ended BNC signal will appear buffered
and inverted on the two outputs with 0.5x gain each, making a total differential gain of 1x
Bandwidth DC – 100kHz @-3dB typical at the WMA-200 high voltage amplifier outputs
Differential output noise between the WMA-200 high voltage amplifier outputs: ~130
µ
Vrms
measured in a bandwidth of DC - 1MHz bandwidth, and ~105
µ
Vrms in a bandwidth of DC -
100kHz
Operating temperature: 15 – 30°C
Storage temperature: 0 – 60°C
Relative humidity: 30 – 70% non-condensing
Maximum usage height: 2000m
Dimensions and weight: 190x106x34mm, 0.4 kg
Power: 28V DC, 200mA maximum, with 315mAT 5x20mm 230V fuse and on/off switch on
rear panel. Use the power supply adapter supplied by Falco Systems only: Mean Well
GS25B28-P1J, 100-240V~ 50/60Hz in, 28V 0.75A DC out, 25W,
with custom MiniDIN
connector
Country of origin: The Netherlands
Specifications may be subject to change
Harmonized standards
This prototype product complies with the
following standards:
Safety: EN61010-1
EMC: EN61326
The
mark is present on the WMA-IB-
LN device to indicate compliance of this
equipment with the European Union safety
and EMC regulations, while the
mark
has been added to indicate compliance
with the United States FCC regulations.
WEEE and RoHS
Do not dispose of this product as standard
waste, but bring it to a WEEE electronic
waste collection point. This is indicated by
the
sign on the WMA-IB-LN. The
WMA-IB-LN has been built in compliance
with the RoHS directive.
Warranty
Falco Systems products are guaranteed
against malfunction due to defects in
materials or workmanship for a period of 1
year from the date of shipment.
If a malfunction occurs during this period,
the product will be repaired or replaced
without charge. The product will be
returned to the customer prepaid.
The warranty does not apply to:
Exterior finish or appearance
Malfunction resulting from use or
operation of the product in other ways than
specified in the user manual
Malfunctioning due to misuse or abuse of
the product
Malfunctioning occurring after changes
or repairs have been made by anyone
other than Falco Systems.
To obtain warranty service, the customer
has to inform Falco Systems first via
[email protected] to receive further
instructions.
Falco Systems will not be liable for any
consequential damages, including, without
limitation, devices or equipment connected
to the product, injury to persons or
property or loss of use. See for more
details the Falco Systems Standard Terms
and Conditions of Sale, which can also be
obtained via [email protected].
