fakro ZWG1, User Manual

Page: 9 / 16

3.5. Excluding device from the network (EXCLUDE function)
Excluding the device from the “Z-Wave” network is possible only with the use of PRIMARY
controller (e.g. ZWK15 keyboard). In each network there is always only one primary controller and every other
is categorized as SECONDARY. The procedure of device excluding from the network is presented in
Figure 6 .
*) Programming error may be caused by:
•
failure to press the programming button within 10 seconds from the controller signaling its readiness for
excluding the device from the network;
•
long distance between the controller and device being excluded.
Note !!! Any device which is physically removed from the network (e.g. damaged) should be deleted from the memory of
the controller (PRIMARY, SECONDARY), that is first deleted from the pair of buttons (section 3.4) and then removed
from the network (section 3.5). The correct implementation of the procedures is to ensure optimal communication
between devices. Unplugging the device without removing it from the controller memory will result in a prolonged
reaction time to commands and faster depletion of the controller battery. If it is necessary to remove the damaged
equipment, whose removal from the controller memory is not possible, it is desirable to reconfigure the whole network
(all devices). Start a new network configuration from restoring the controller to the factory settings (DEFAULT function),
then call the EXCLUDE function of devices working correctly and continue to the section 3, "Controller Programming".
Note !!! Moving the device within the network (e.g. socket module) it is recommended to delete it from the controller
memory (delete it from the pair of buttons first (section 3.4) and then remove from the network (section 3.5) and then add
it again after installation in new place of work.
11.11.15 NC818 9/16 ©2012, FAKRO
Figure 6: Excluding device from Z-Wave network
5* . Programming error – button
flashing for 10 sec. as presented in
the drawing.
4 . The controller is signalizing that the
device has been excluded successfully
(button lights up for 2-3 sec. as
presented in the drawing.).
1 . Press “ In/Ex ” button twice
within 1 sec.
3. Press “P” button on the device and
hold it for 0.5 sec. (see Device
Programming Manual).
2 . The controller is signalizing its readiness
for excluding the device from the network
(button lights up for 10 sec. as presented in
the drawing).
x1
x2
Note!!!
In the newer controller version, interrupting any procedure is possible by pressing the “IN/EX” button. In the
older version, it is necessary to wait 10 seconds until the error is signalled by the controller or reset it by removing the
batteries.