11
Electrical Safety
WARNING!
Read these electrical safety instructions
carefully before connecting the charging
adaptor to the mains supply.
Do not leave your charging adaptor
connected to the mains supply when not in
use.
This vacuum cleaner is supplied with a
charging adaptor which has been designed
for indoor use only.
Before plugging the charging adaptor into
the mains supply, make sure that the voltage
of your electricity supply is the same as that
indicated on the rating plate on the charging
adaptor.
The charging adaptor is a sealed unit. There
are no user serviceable parts inside and it
does not require any electrical adjustments.
WARNING!
Do not attempt to open the charging adaptor.
If the charging adaptor is not suitable for
your socket, becomes damaged, or fails to
charge your battery, it must be replaced and
disposed of in a safe and environmentally
protective way. Always refer to qualified
personnel.
This charging adaptor is designed to operate
on 230VAC 50Hz supply only.
Connecting it to any other power sources
may damage the unit.
Do not allow the cleaner, or the charging
adaptor to be exposed to rain or moisture.
Regularly inspect the charging adaptor and
the lead for damage.
Do not use it if faults or damage are found.
Refer to qualified service personnel.
This symbol indicates that this
charging adaptor is a Class II
appliance and does not require an earth
connection.
Operating Instructions
INSTALLING THE WALL MOUNTED
CHARGING BASE
It is recommended that the charging base
should be mounted on a wall to provide a
convenient storage and charging point for
the cleaner.
1- Find a suitable indoor wall location near a
mains power socket but out of the reach of
children. Do not mount the charging base
in direct sunlight or close to a heating source.
Ensure that there are no hidden electrical
wires or pipes in the chosen location.
2- Position the charging base as shown in
figure 1.
3- Mark the location of the mounting holes and
drill two suitable holes.
4- Make sure that the charging adaptor lead
is threaded through the slot in the charging
base. See figure 2. Excess lead can be
stored at the rear of the charging base.
5- Screw the charging base to the wall.
1
2
Slot
