Important! Before Fitting!
If at all possible, do steps 1-2 one to two days before first use. This is to allow the adhe-
sive on the hook and loop to cure.
Important! Club Cars 1983-07!
If you have a 1983 to 2007 Club Car you will need to install an adapter bar after step 2.
Please refer to the instructions with the adapter bar.
If the adapter bar is not included with this enclosure you can get one from your retailer or
from Classic Accessories.
Tools Needed:
Scissors
Small wood block or piece of cardboard
1. Apply adhesive hook strips to your car front roof posts.
Remove your enclosure from the storage bag and locate the plastic bag holding the adhe-
sive backed hooks strips. Remove the two longest 32” strips.
If you have a folding windshield skip to step 1b.
1a. For non-folding windshields:
Attach one of the 32” strips to the outside (not the front) of one
of your cars’ front roof posts on either side of the windshield. Hold
the strip vertical and peel an inch or so of the adhesive backing from
the top end. Align the strip along the roof post, with the top of the
strip just where the post straightens or below the roof line. Slowly
peel of the backing as you press the strip down the post. If there is
a plastic windshield channel attached to the post cut the
strip at the edge of the plastic and start a new piece on the
aluminum post.
Using a small wood block or piece of cardboard press the strip firmly
down along the entire length of the post.
Now put the other 32” strip on the oposite roof post.
1b. For folding windshields:
If you have a folding windshield you can follow the instruc-
tions above in 1a except you need to cut the adhesive
backed hook strip to allow for the rubber windshield fit-
tings.
Fold your windshield up and mark the top and bottom where the
rubber fitting cinches on the roof post.
Cut the 32” strip into individual pieces to go above and
below your marks and then attach them to the roof posts.
Wait for two days for the glue to cure before proceeding.
72042 (page 3 of 7)
12.18.09
