Customer Help Line:
+27 087 740 2101
This design and instruction booklet is subject to copyright.
www.Fairprice.co.za
ASSEMBLY
1
ON A FLAT SURFACE IDENTIFY THE TOP (PART 1) ,BOTTOM (PART 2) AND SIDES
STRETCHER (PART 3) THEN POSITION THEM AS SEEN THEN WITH AN ALLEN KEY AND
CONFIRMAT SCREW FASTEN THE 4 PARTS TOGETHER.
2
3
2
IDENTIFY THE INSIDE - STRETCHER (PART 4) THEN INSERT IT IN BETWEEN THE TOP AND
BOTTOM, THEN ALIGN THE DRILLING OF THE TOP AND BOTTOM WITH THAT OF THE
INSIDE STRETCHER (PART 4) WITH AN ALLEN KEY AND CONFIRMAT SCREW FASTEN THE
(PART 4) ONTO (PART 1) AND (BOTTOM 2).
4
3
4
IDENTIFY THE BOTTOM FACE (PART 7) AND ALIGN IT FLASH WITH THE BOTTOM
STRETCHER AND BOTH SIDE STRETCHERS AS SEEN POSITION THE BRACKETS THEN WITH A
8x16mm SCREW FASTEN THE BRACKETS ONTO THE STRETCHERS AND THE BOTTOM FACE
"PLEASE MAKE SURE THE SURFACE IS CLEAN TO NOT DAMAGE THE BOTTOM FACE"
REPEAT THIS STEP FOR FOR THE REST OF THE FACES.
4
5
WITH ALL THE FACES FASTEN POSITION THE UNIT IN AN UP RIGHT MANNER, WITH
ASSISTANCE INSERT THE DOWELS ONTO THE DRILLING ON THE TOP FACE (PART5) THEN
POSITION THE SHELF (PARTY 8), WITH AN ALLEN KEY AND CONFIRMAT FASTEN THE SHELF
FROM THE BACK WITH HELP FROM ANOTHER PERSON HOLDING FROM THE FRONT ONCE
COMPLETED REST THE UNIT ON THE GROUND WITH ITS BACK TO AVOID DAMAGE.
5
3/4
IDENTIFY THE TOP (PART 9) AND BOTTOM (PART 10) BY HAND INSERT THE DOWELS AND
WITH A SCREW DRIVER FASTEN THE PIN SCREWS ONTO THE PARTS.
6
IDENTIFY THE SIDE AND SLIDE IT IN THE PINS AND DOWELS THEN INSERT THE CAM WITH
A SCREW DRIVER TWIST THE CAM TO LOCK THE SIDE INTO POSITION THEN INSERT
DOWELS ONTO THE DRILLED HOLES ON THE SIDE THEN INSERT THE SHELF 2 (PART 13).
THEN REPEAT THE STEP WHEN INSERTING THE DIVISION (PART 12) "PLEASE NOTE START
FROM ONE SIDE TO ANOTHER DO NOT START FROM CENTER"
1
1
2
TOP ASSEMBLY
11
13
2
START HERE
BOTTOM ASSEMBLY
