10
5. Attention
• Read the user manual carefully before operating the device.
• Only operate InvoMatic with a designated AC power outlet.
• Place the power cord out of the way of the inversion arm to avoid a trip hazard.
• Keep hair tight and avoid loose clothing when operating the device.
• Place InvoMatic on a flat surface, allowing 10 cm of clearance on all sides of it.
• Don’t operate the device with a wet or damp hand, or on wet or dump surfaces.
• To avoid injury, keep hands and other body parts away from the inversion arm during mixing.
• Don’t change the mixing vessel without switching "OFF" the power button.
• Don’t place any parts of InvoMatic into a dishwasher or autoclave.
• When moving the device, make sure the power switch is turned "OFF" and the power cord disconnected
from the power supply.
6. Maintenance
6.1 Cleaning
• InvoMatic can be cleaned with a damp cloth and normal household cleaners.
• Never submerge the device.
6.2 Troubleshooting
The troubleshooting section of this manual covers basic troubleshooting for common issues with the InvoMatic.
If the following troubleshooting guide does not resolve the problem, contact your local supplier for further assis-
tance.
Problem
Possible Solution
The arm is making noise when rotating
Some noise is permissible, different conditions will
cause some different noises to happen.
Stop rotation, turn the power switch "OFF",
and check if the arm is attached correctly.
The arm is not rotating
Turn the power switch "OFF", and remove any
obstructions from the arm.
Check if the screw is tight using the tool provided.
Check if the screw is located on the flat portion
of the shaft.
The arm rotates but the vessel is not rotating
Check if the orange drive belt is engaged correctly.
The arm is not rotating and there is a loud noise
Turn the power switch "OFF", and remove any
obstructions from the arm.
Check if the content of the vessel is not too heavy,
as this will cause the arm to stop.
The screen light is on, but not responding
Turn the power switch "OFF" and unplug the device
from the power source. Plug the power source back
and turn the power switch "ON".
The device has stopped but I can’t set
the Timer or Speed
Press the "STOP" button twice to allow setting.
Summary of Contents for InvoMatic
Page 1: ...InvoMatic User Manual www fagronlab com ...
Page 2: ......
