Fagor QR-1, Installation, Use And Maintenance Manual

Page: 6 / 28

www.Fagorcommercial.com
PAGE 6
REACH-INS OPERATIONAL SERVICE MANUAL / Rev.JUN. 2015
3 INSTALLATION
3.1 UN CRATING
Remove the outer packaging.
Cut the 4 clamps that hold the refrigerator to the skid. Lift the unit off
the skid.
If machine was laid down during this operation, remember to leave the cabinet up
right for 24 hours before connecting to power source.
3.2 LOCATION
Units represented in this manual are intended for indoor use only. Be sure the location chosen has a
floor strong enough to support the total weight of the unit and its contents. For the most efficient
operation, be sure to provide at least three (3) inches between sides, back and top of the unit.
THE MACHINES NEEDS TO BE INSTALLED 2 FEET AWAY FROM ANY HEAT SOURCES .
The unit should not be installed under ambient temperatures higher than 100 °F.
If the relative humidity is higher than 60 %, the door frames may sweat water. This is not a
malfunctioning of the unit.
WARNING
The following actions will void your warranty:
-Modification of power cord.
-Connecting the unit to any extension cord.
-Neglecting to install the castors or optional legs.
Inside cabinet:
The first cleaning must happen when you unpack the unit and before it is turned ON. For this, you
have to clean the unit with warm water and mild detergent. When it is cleaned and dry, proceed to
install accessories and plug your unit into a dedicated outlet.
WAIT 24 HOURS BEFORE PLACING
PRODUCT IN THE UNIT . This will guarantee that it is working properly. Consequential damages are
not covered under warranty.