OPERATION
shown on the display. This message prompts
you to descale the system. Select P10S from
the list of pre-set programmes to descale the
appliance. You can skip descaling twice, by
touching the sensor. However, eventu-
ally the appliance will not allow you to run a
steam programmes again until you descale
the appliance.
Descale the appliance.
•
Prepare the solution of 450 ml of water
and 50 ml of liquid descaling agent.
•
Pour the solution into the water contain
-
er drawer.
•
Press OK to start the P10S programme.
NOTE: During the descaling programme,
you will need to drain water from the steam
system 3 times.
Drain the descaling solution from the system
when you hear a beep and steam indicator
is flashing.
• Open the oven door.
• Then place deep baking tray under the
water drain.
•
Press OK to drain the remaining des
-
caling solution from the steam system.
Pour the solution out of the baking tray
and rinse it with water.
To rinse the steam system, pour 0.5 l of clean
water into the water container drawer and
touch OK to continue the steam programme.
Drain the descaling solution from the system
when you hear a beep and steam indicator
is flashing.
• Open the oven door.
• Then place deep baking tray under the
water drain.
•
Press OK to drain the remaining des
-
caling solution from the steam system.
Pour the solution out of the baking tray
and rinse it with water.
IMPORTANT: If water is dripping from the
drain tube during the steam programme, flush
the system. In the active oven mode without
the function enabled:
•
Place at least 1 litre container under the
drain.
•
Pour 0.5 litres of water into the water
container drawer.
• Simultaneously touch and OK and
drain water out of the system.
• Repeat this procedure twice.
If the problem persists, descale the appliance.
IMPORTANT: If you notice scale draining from
the steam system after the completed steam
programme, select the P10S programme from
the list and follow the descaling instructions.
If you pour water into the container but decide
not to run a steam programme, you can touch
and OK to drain water from the steam
system. You can touch OK at any time to stop
draining water.
Oven door
Oven door must be closed during operation.
When you open the door you will interrupt the
active oven function. If the door remains open
for more than 30 seconds, an acoustic signal
will sound to prompt you to close the oven
door. Touch any sensor or close the oven door
to mute the beeping.
If you open the door for less than 10 minutes
the active settings are unaffected. For safety
reasons, after this time, the oven enters the
standby mode (all settings are cleared).
Limit the oven operating time
For safety reasons, the oven operation is time
limited. If the set temperature is up to 100°C,
the oven will enter Standby mode after 10
hours, and if the set temperature is 200°C and
more, the oven operation is limited to 3 hours.
In the temperature range of 101°C to 199°C,
the operation time is limited proportionally
56