Fagor FDO800X, User Manual

Page: 8 / 27

Warning
We cannot be held responsible for any accident resulting from inexistent, defective
or incorrect earthing.
If the electrical installation in your residence requires any changes in order to hook up your
appliance, contact a professional electrician.
If the oven malfunctions in any way, unplug the appliance or remove the fuse corresponding
to the sector where the oven is hooked up.
You must enable the appliance to be disconnected from the supply network after installation.
Disconnection can be enabled by ensuring that there is an accessible power plug or by incor-
porating a switch into the fixed wiring in compliance with the installation rules.
The oven is sold without a cable.
8
The electrical connections are made before the oven is in-
stalled in its housing.
• Before connecting your oven, make sure you are using
the correct size cable. The cross-section should be the
same as the cable connected to the oven. The fuse for your
installation must conform to the table shown opposite.
• Where the oven is connected using a separate plug and
socket this must be accessible after the oven has been in-
stalled.
• Where the appliance is not connected to the mains elec-
tricity supply by a plug, an omnipolar cutout
device (with a contacts gap of at least 3 mm) must be fitted
on the supply side of the connection to meet
requirements.
• The oven must be connected using a standard power
cable for which the number of conductors is
dependent upon the type of connection required and in
conformity with the table shown below.
E E
LECTRICAL CONNECTIONS
min.
network voltage connection diameter fuse
of cable
➀
230V- 50Hz 1 L + N 4 mm² 32 A
➁
400V 2N-50Hz 2 L + N 1,5 mm² 16 A
230V 2-2N-50Hz 2 L + N 1,5 mm² 16 A
3
HOW TO INSTALL YOUR OVEN
1
2
5 4 3
1 2 5 4 3
1
2 5
4
3
➀
➁
③
T
N
T
T
N
N
Ph 2