Fagor Eco Concept CCO-120, Service Manual

Page: 37 / 79

02/05/2020 36
SERVICE MANUAL
CONVEYOR BELT
DISHWASHERS
Fig. 13
Connection strip DE (Fig. 3/Fig. 4 ).
Connection A

1 / 2

Tube fill and rinse active signal.
Connection B

1 / 3

Rinse active signal.
Connection C  1 / 4  Wash pump active signal.
Connection D

1 / 5

Electrical connection at 230 V 1N~ (max.
1A) when the appliance is on.
Connection

Earth.
Connection E

6 / 5

Connection for extra emergency button.
Connection F

7 / 5

Limit switch connection.
On completion of the electrical connection, the cover of the electric panel must be replaced and secured.
19.9. LIMIT SWITCH/MICRO SWITCH
The limit switch/micro switch is mounted at the end of the dishwasher output bench, where it is activated when the
basket reaches the end of the bench, and the machine operation is stopped. When the limit switch is released on
removing the baskets from the bench, the machine continues with the wash.
The electrical connection cables of the limit switch / micro switch must be inserted through the packing gland DSR
(Fig. 3/Fig. 4 ) and connected to the DE terminal strip at connection 7 / 5 as with the dispensers (see Fig.13 .).
On completion of the electrical connection, the cover of the electric panel must be replaced and secured.
19.10. EXTRA EMERGENCY BUTTON
The appliance also permits the installation of an extra external emergency button in the location required.
The electric connection cables must be inserted through the DSR packing gland and connected to the DE terminal strip
at connection 6 / 5 as with the dispensers.
On completion of the electrical connection, the cover of the electric panel must be replaced and secured.
20. SAFETY LOCKING SYSTEM
The machine is fitted with a safety locking system, which stops the appliance and notifies the user with a light and
acoustic signal if a blockage or impediment is detected in the feed system.
This system must be adjusted if the dishwasher has accessories such as automated input and/or output benches
which require a greater feed force than the force configured as standard, as a greater weight is carried on the belt.
If the dishwasher has automated input and/or output benches which require
a greater feed force, the spring supplied in the kit must be installed.
The additional spring must not be installed without checking that it is really
necessary, as this could damage the appliance.
To adjust the system first disconnect the water using the shut-off valve, and then the electricity, using the magneto-
thermal switch/ setting the mains switch IG to OFF .