Fagor 6HV-585A TC X, User Manual

Page: 8 / 22

8
2 / INSTALLING YOUR APPLIANCE EN
• • ELECTRICAL CONNECTION
20A Single phase meter
220-240V~ 50Hz
Plug with
2 pins + e ea arrtth h CEI
60083 standard
Single phase line 220-240 V ~
Power cable length
approx. 1.50 m
Differential circuit breaker or
10A fuse
Electrical safety should be ensured by correct
recessed fitting. During fitting and
maintenance operations, the appliance
should be unplugged from the mains and the
fuses should cut out or removed.
The electrical connection should be made
before the appliance is put in place in the unit.
Check that:
- The mains power is sufficient
- The power cables are in good condition
- The diameter of the wires complies with the
installation regulations.
Your oven should be connected with a
standard 1,5mm2 3 conductor cable (1ph + 1N
+ earth) which should be connected to the
220-240V~single phased network by standard
1 phase + 1 neutral + earth CEI 60083 plug
or a double pole cut-out device in accordance
with the installation regulations.
It should be possible to disconnect the
appliance from the mains, either through the
use of a plug or by fitting a switch to the
stationary conduits in accordance with the
installation regulations.
Warning
The earth wire (green and yellow) is
connected to the terminal of the
appliance and should be connected to the
earth of the installation.
In the event of connection with a plug, it
should be accessible after installation.
The fuse of the installation should be 10
amps.
If the power cable is damaged, it must be
replaced by the manufacturer, its After-
Sales Service or similarly qualified persons
to avoid danger.