27
TURN ON THE APPLIANCE AND SE
-
LECT PROGRAMME
Turn on the appliance
1. Draw out the lower and upper basket, load the dishes and push them back. It is
commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. Make sure that the water supply is turned on to
full pressure.
4. Open the door, press the Power button.
5. Choose a program, the response light will turn on. Then close the door, the dish-
washer will start its cycle.
Change programme
You can change the programme only if it runs for a short time. Otherwise the deter-
gent is already dissolved in water and the water could be pumped out. In this case,
refill the dispenser with detergent and start the washing program from the beginning.
To reset your dishwasher, please follow the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stop working,
you can open the door completely.
2. Press Program button for more 3 seconds to cancel the current program and the
machine goes into standby state.
3. You can change the program to the desired cycle setting.
Add dishes during the programme:
You can add extra dishes at any time before detergent is released. In this case, follow
the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door, the dishwasher will continued to run after 10 seconds.
WARNING!
Be careful when opening the door during the dish-washing programme as hot steam
can be released and cause scalding.
