Introduction
Page 2/28
1.1
Related documentation
Before configuring and operating the VISY-Command central unit, the level and environmental
sensors must be installed and connected to it. The VISY-Command is then configured with the
VISY-Setup software via a PC or notebook. Please also observe the additional instructions in
the following technical documentation:
VISY-Setup V4
…
, art. no. 207158
VISY-Stick VISY-Reed, art. no. 207194
For the installation and commissioning of the VIMS sensors please contact:
SGBGmbH, Hofstraße 10, 57076 Siegen, Germany
Tel.: +49 271 48964
–
0, Fax: +49 271 48964-6, E-mail:
The VISY-SoftView software application is used for the display module in the VISY-Command
GUI and in the VISY-View Touch. VISY-SoftView provides the capability to view current tank
data, delivery data and the various alarms signalled by the VISY-Command central unit. For
configuration and operation of the display module with VISY-SoftView see the following
technical documentation:
VISY-SoftView User Guide, art. no. 350026
VISY-SoftView Administrator, art. no. 350144
The probes VISY-Stick Oil separator and VISY-Sludge are used for monitoring of oil separators
(
COMS Continuous Oil separator Monitoring
). The sensor VISY-Stick Oil separator continu-
ously monitors the height of the light-liquid layer, VISY-Sludge continuously monitors the
height of the sludge layer. For installation and operation see the following technical documen-
tation:
COMS Technical data, art. no. 350273
COMS Installation Quick Guide, art. no. 350240
COMS oil layer table, art. no. 350007
VISY-SoftView Oil separator, art. no. 350193
1.2
Requirements for service engineers
The complete VISY-X system should only be installed by trained service engineers.
