How to send and receive
<ENTER> = press the ENTER key
Sending to machine
ShopLink FLASH is powered up with the “FILE” led on, ready to send (select “SEND” folder).
At the machine, press the manual key until the ENTER NEXT COMMAND prompt is showing.
Enter TA,1
<ENTER>
.
Receiving from machine
ShopLink FLASH is powered up with the “FILE” led on, ready to receive (select “RECEIVE” folder).
At the machine press the manual key until the ENTER NEXT COMMAND prompt is showing.
Enter PU,2
<ENTER>
.
ShopLink FLASH “FILE” led will go off after 10 seconds, power off and remove FLASH drive.
There are different values that can be used with the PU command listed below:
Value
Description
0
Program, tool and fixture data
1
Tool and fixture data only
2
Program only
3
All programs in memory
DNC Operation
If you want to drip feed the Nc code to the machine because it is to large for the memory.
ShopLink FLASH is powered up with the “FILE” led on, ready to send (select “SEND” folder).
At the machine press the manual key until the ENTER NEXT COMMAND prompt is showing and enter
DNC
<ENTER>
.
Press the cycle start button at the machine.
