Fadal CNC 88, CNC 88HS and MP-32
Machine Parameters
Strictly speaking it is is not necessary to change any parameters. All that needs configuring is the Baud Rate.
This can be changed by using the CD command, but this change is not retained on power off.
To change using the CD command:
Press the manual key until the ENTER NEXT COMMAND prompt is showing and enter CD, followed by a number
listed below that represents the required baud rate. For example CD,8 would set the baud rate at 9600.
Value
Baud Rate
1
110
2
150
3
300
4
600
5
1200
6
2400
7
4800
8
9600
9
19200
10
38400
To change using the machine parameters
To change the baud rate so it is retained on power off. Press the manual key until the ENTER NEXT COMMAND
prompt is showing and enter SETP. Press ENTER until the Baud Rate parameter is selected. Key in a number
from the above table and then press the ENTER key. Press MANUAL to exit the parameters.
Other Settings
All Fadal controls have the settings detailed below. These are fixed and cannot be changed with the machine
parameters.
Hand Shaking
XOn/XOff
Parity
Even
Data Bits
7
Stop Bits
1
