Factory Cat 28, Operator And Parts Manual

Page: 13 / 43

PAGE 11
ONE PASS SCRUBBING
STEPS: (SEE FIGURE 16.)
1. TURN MACHINE ON, MAKE SURE THE SPEED
KNOB IS AT THE LOWEST SETTING.
2. LOWER SQUEEGEE BY MOVING THE LIFT LEVER
ALL THE WAY TO THE RIGHT
3. LOWER SCRUB HEAD TO THE FLOOR, USE THE
TOP HALF (+) OF THE BRUSH SWITCH.
4. TURN ON THE SOLUTION SWITCH AND ADJUST
THE SOLUTION LEVER TO THE DESIRED SETTING.
5. BEGIN SCRUBBING BY HOLDING THE GREEN
CONTROL BUTTONS. ADJUST THE SPEED
CONTROL KNOB TO THE DESIRED SETTING.
6. ONCE THE MACHINE BEGINS TO MOVE,
CHECK THE DOWN PRESSURE GAUGE. START
SCRUBBING AT THE #1 OR # 2 MARKS, DO NOT
USE THE #4 OR #5 MARKS WITH OUT
MANAGEMENTS APPROVAL.
7. TO OPERATE MACHINE IN REVERSE,
SIMPLY PULL THE REVERSE SWITCH BACK
TOWARDS THE HANDLEBAR. YOUR REV SPEED IS
SET TO ROUGHLY 50% OF FORWARD.
8. TO STOP THE MACHINE, LET GO OF THE GREEN
CONTROL BUTTONS.
OPERATION
PRE-CLEANING CHECK LIST
READ AND UNDERSTAND THE SAFETY SECTION ON
PAGE 5 AND 6 BEFORE OPERATING MACHINE.
1. CHECK BATTERY CONDITION GAUGE ON
THE CENTRAL COMMAND II LCD SCREEN.
TO CHECK GAUGE PUSH MENU CONTROL
BUTTON UNTIL BATTERY GUAGE APPEARS.
MAKE SURE BATTERIES ARE FULLY CHARGED
BEFOR USING.
2. CHECK THE CONDITION OF PADS OR BRUSHES.
3. CHECK THE CONDITION OF THE SQUEEGEE BLADES.
4. TRANSPORT THE MACHINE TO THE FILLING
STATION. RASISE THE SCRUBHEAD AND
SQUEEGEE WHEN TRANSPORTING.
5. TURN MACHINE OFF.
6. OPEN SOLUTION FILL DOORIN THE FRONT OF
THE MACHINE AND FILL THE TANK WITH UP
TO 30 GALLONS OF CLEAN WATER. THE
CLEAR TUBE AT THE REAR OF THE MACHINE
INDICATES THE AMOUNT OF WATER IN THE TANK.
7. ADD CLEANING CHEMICAL. USE THE PROPER
DILUTION RATIO INDICATED ON THE BOTTLE.
NOTE: USE ONLY NONFLAMMABLE COMMERCIAL
CLEANING CHEMICALS. YOUR AUTHORIZED
DISTRIBUTOR CAN ASSIST YOU IN SELECTING A
PROPER CHEMICAL.
FIGURE 15.
FIGURE 16.