3
STAND & COLUMN UNIT ASSEMBLY
1. Unpack the packing box and check the parts by referring to the parts diagram.
Loosen the 4 screws in the center of the stand. Place the column on the stand
and align the screw holes. Then tighten the screws. (See Fig.1)
2. Unscrew the height adjustment ring located at the top of the column.(See Fig.2)
3. Slide the decorative sleeve down over the external pole. (See Fig.3)
4. Reattach the height adjustment ring. (See Fig.4)
5. Loosen the height adjustment ring and adjust the internal
pole to the desired height. (Note: If you can’t see the internal pole, it has slid
inside the external pole and can be pulled out.) (See Fig.5)
6. To attach the fan head unit to the column, loosen the thumb screw on the bottom
of the fan head.
7. Place the fan head on the column and tighten the thumb screw in alignment with
the groove on the internal pole. (See Fig.6)
GRILLE & FAN BLADE ASSEMBLY
1. Remove the plastic nut by turning it counterclockwise.
2. Place the rear grille over the motor shaft and against the motor housing.
3. Screw on the plastic nut (clockwise) securing the fan grille to the fan head.
(Step 1,2,3 see Fig.7)
4. Discard the small plastic sleeve located on the motor shaft.
5. Place the fan blade onto the motor shaft. Make sure the retaining pin of the motor
shaft fits into the slot in the centre of the fan blades.
6. Attach the spinner to the motor shaft by turning it counterclockwise to secure the
fan blade. (Step 4,5,6 see Fig.8)
7.
Mount the front grille and join both grilles together using the clips.
(Step 7 see Fig.9)
Clip
Loosen
Tighten
Tighten
Loosen
