8
top right hand corner.
Note – If the begin test icon is in grey this will be
because the instrument’s memory is full (20 tests
maximum) and you need to remove at least 1 test
before you can proceed. See Section 4 –
Reviewing Test Results for further details.
3.
Selecting the test standard and configuring the instrument
From the main menu press the configure icon.
In the configuration sub menu there are 3 icons
available, from left to right these are:
Set Date
Set Time (the instrument uses a 24 hour clock)
Set units of measure and test standard
To set the date, press the calendar button on the
display as seen above.
In this menu you can then choose date format;
DD/MM/YYYY or MM/DD/YYYY
Summary of Contents for F4504
Page 1: ...0 F4504 MULTI AIR TESTER OPERATING MANUAL FAC QAM 173 Issue G 03 21...
Page 2: ...1...
Page 46: ...45 Water mg m3 to PPM v v Conversion Charts...
Page 47: ...46...
