D208 – 2022 11 01
2
www.facespa.it
SW80MC
Mechanical coordinator for two swing leaves
The mechanical coordinator SW80MC is a device that is used to allow correct closure of the two leaves of a swing
door, so that the MASTER leaf that opens first is closed after closing the SLAVE leaf, in accordance with the EN
1158 standard.
The mechanical coordinator SW80MC is included inside the automations for doors with two swing leaves, made to measure
(see codes SW80S1D20MC and SW80S1D30MC) and ordered using the X105-2 form.
To regulate the functioning of the mechanical coordinator it is necessary to strictly follow the following instructions.
Use drawing 1 for the SW80 automation with articulated arm, with the Master leaf on the left and the Slave leaf on the right.
Use drawing 2 for the SW80 automation with articulated arm, with the Slave leaf on the left and the Master leaf on the right.
Use drawing 3 for the SW80 automation with sliding arm, with the Master leaf on the left and the Slave leaf on the right.
Use drawing 4 for the SW80 automation with sliding arm, with the Slave leaf on the left and the Master leaf on the right.
1) The SW80S1D20MC and SW80S1D30MC automation is supplied assembled to measure. To facilitate wall installation, it is
possible to disassemble the 3 components that form the mechanical coordinator.
- Using the 2 screws (A) and 3 screws (B) the connecting rope (F) of the MASTER and SLAVE automations is disassembled and
reassembled. The length of the connecting rope (F) of the MASTER and SLAVE automations is calculated using the formula
shown in the figure 3.
- Using the screw (C) and the 2 screws (D) the MASTER automation device is disassembled and reassembled.
- Using the screw (E) the SLAVE automation device is disassembled and reassembled.
2) Before reassembling the mechanical coordinator, install the automation as indicated in chapter 4 of the D184 installation
manual. Manually open the 2 leaves of the door and check that the spring closure is regular.
3) Reassemble the mechanical coordinator, as indicated below.
- PLACE THE 2 DOOR LEAVES IN THE CLOSED POSITION.
- Using the screw (E) fix the SLAVE automation device in the position indicated in figure 1.
- Using the screw (C) and the 2 screws (D) fix the MASTER automation device.
- Fully insert the connecting rope (F) into the SLAVE device and fix it with the 3 screws (B).
- Manually open the SLAVE leaf and hook the connecting rope (F) into the MASTER device, as shown in the figure, and fix it
with the 2 screws (A).
4) To adjust the angle (X) of intervention of the mechanical coordinator proceed as follows.
- MANUALLY OPEN THE SLAVE LEAF AT 90°.
- Manually open the MASTER leaf at an angle (X) that allows the SLAVE leaf to be closed, as shown in the figure 2.
- In the MASTER device, unscrew the screw (C) and manually rotate the washer (G) until it touches the bracket with spring
(H), as shown in the figure 3.
- Screw the screw (C) and check that the MASTER leaf stops.
- Release the SLAVE leaf so that it moves to the closed position, and check that the MASTER leaf closes after the SLAVE leaf
has passed.
- Manually repeat the opening of the leaves and check the correct closing sequence.
EN
