Rotating the spring drive wheel counterclockwise
Right end of spring drive wheel with pin in notch
Turn counter-clockwise
to
increase speed
Right side, spring drive wheel
Flat surface on wheel
(to help in counting the revolutions)
The upper limit stop
STEP 2 - ROLLER SHADE INSTALLATION
(continued).
STEP 3 - ADJUST THE SHADE SPEED.
Adjust the speed at which the shade will rise. The shade
speed is set at the factory. However, the selected speed
may be too slow or the tension may have loosened during
shipping.
To make an adjustment, locate the spring drive wheel on
the right side of the shade. Hold shade with the left hand
and turn the spring drive wheel counter-clockwise. This will
tighten the tension on the shade to help it roll faster.
IMPORTANT!
DO NOT TURN the
wheel more than
21 FULL REVOLUTIONS.
STEP 4 - SETTING THE UPPER LIMIT STOP.
This is the location where the shade will stop when raised.
Simply raise the shade to the desired stopping location
by turning the brake wheel on the left side of the shade.
Nothing more is required.
STEP 3 - ADJUST THE SHADE SPEED
(continued).
Note: There is a flat surface on the wheel to help in counting
of the revolutions. If the tension is too tight, lift the
right pin
only
out of the bracket, and the tension will release.
Desired stopping
location of
shade
Flat surface
