SSS1507DMLSII
© 2015 Fabritec, LLC. All rights reserved.
EST
. 19
73
EST
. 19
73
- page
4
of
4
-
STEP 4 - ADD THE END CAPS FOR A FINISHED LOOK.
Note: The end caps cannot be used on an inside mount
installation.
STEP 5 - INSTALL THE P-CLIP (HOLDDOWN).
Depress the p-clip holddown and firmly attach to the wall.
DO NOT PULL THE BEAD CHAIN TAUT, as this will prevent the
bead chain from operating smoothly.
P-clip installed
STEP 2 - INSTALLING THE SHADES
(CONTINUED)
.
FOR THE DUO LINK SYSTEM
d) Next install the shade with the female coupler end. The
control end of this shade must be installed first. Gently
slide the bracket pin into the middle of the cross shaped
hole of the end bracket, and pull down to lock in place.
e) Then depress the male coupler end of the first installed
shade to ease the female end of this shade into place (a
putty knife is helpful for this step).
STEP 3 - SET THE LOWER LIMIT/STOP POSITION
.
Lower the shade to the desired long point. Then pinch the
bead chain at this point on the front of the clutch, and place
one of the bead chain stops here. One extra bead chain stop is
provided in case a change must be made.
If installing a Duo Link, this step will be necessary for both shades.
Completed
Duo LInk installation
pinch bead
chain here
Caring for your Duo & Multi LInk Systems,
Clutches & Roller shades
Your Duo or Multi Link systems, clutches and roller shades will
provide you with years of beauty and pleasure with minimal
care and cleaning.
• Vacuum using a brush or dust head attachment.
• Dust lightly using a soft, clean cloth.
• Never immerse the clutches or shades in water or liquids
of any type.
Call us at
800.828.2500
if you have any questions.
1
3
2
