GB
GB 9
GB
GB 8
4.7 LIGHTING/EXTINGUISHING THE BURNER
Starting the burner
Turn control knob B to setting 1. The burner will light. The
temperature can be set by turning the knob to the desired setting
between 1 and 7, setting 7 giving the highest temperature
The slide control can only be used when control knob B has been
turned past the
|
.
Moving the slide control upwards causes the burner to light. The
further upwards the slide control is set, the higher the flames..
Turning off the burner
The thermostatically controlled tap is switched off by setting the
control knob B to the left of 1. You can now set the slide control.
The slide control is switched off by sliding it downwards to the
{
setting.
When control knob B is turned to the
|
setting, only the pilot light
continues to burn. Both burners are out.
When control knob B is turned to the
|
setting, only the pilot light
continues to burn. Both burners are out.
4.5 LIGHTING/EXTINGUISHING THE PILOT FLAME
LLiig
gh
httiin
ng
g tth
he
e p
piillo
ott fflla
am
me
e
Turn control knob B to setting
|
and push it in. Push knob A in a
few times in succession until the pilot flame is ignited by a spark.
You now hear a tick. Once the pilot flame is alight, keep the knob
pushed in for another 30 seconds. The pilot flame will now stay
alight.
T
Tu
urrn
niin
ng
g o
offff tth
he
e p
piillo
ott fflla
am
me
e
Turn the knob to
|
, press it in and turn it to the right to
the
{
setting.
4.6 WHEN THE PILOT FLAME GOES OFF
W
Wa
arrn
niin
ng
g!! When the pilot flame goes out, for whatever reason, you
should wait at least 5 minutes before trying to turn it on again
Possible causes of extinction of the pilot flame are:
- operating error
- interference of the security, caused by a bad chimney functioning;
- failure in the pilot flame system;
Contact your installer when the appliance goes off regularly..
