Faber HEAVEN GLASS 2.0, Instruction Manual

Page: 8 / 46

EN 8
USE
Control panel
Button Led
Function
L
- Turns the lights ON/OFF at maximum strength.
Press and hold the button for approximately 5 seconds, with all the loads turned off (Motor
and Lights), to turn the Activated Charcoal Filter alarm on. The 4 LEDs on the buttons flash
twice to confirm
To turn the alarm off, press the button again and hold for at least 5 seconds. The 4 LEDs on
the buttons flash once.
T1
Fixed Turns the motor on/off at speed one.
Flashing 24h function
Press and hold the button for approx. 2 seconds to Activate/Deactivate the motor in 24h Air
Circulation mode, a speed that allows ducting for 10 minutes every hour, for a 24 hour
cycle.
Cannot be activated if Intensive or Delay modes are active.
T2 Fixed Turns the Motor on at speed two.
Flashing
Delay function :
Press and hold the button for approx. 3 seconds to Activate/Deactivate the Delay function
(automatic switching off of the Motor, the Fans and the Lighting with a 30' delay).
Cannot be enabled when Intensive or 24h are on.
T3 Fixed Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads turned off (Motor
and Lights), to reset the Filter saturation alarm. The LED
S1 flashes three times.
T4
Fixed Turns the Motor on at Intensive Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system returns
automatically to the speed that was set before. If it is activated with the motor turned off, the
hood will switch to OFF at the end of the time.
Press and hold for 5 seconds to enable the remote control, indicated by the LED flashing
twice.
Press and hold for 5 seconds to disable the remote control, indicated by the LED flashing just
once.
S1
Fixed Signals the Metal Grease Filter saturation alarm, indicating that it is necessary to wash the
filters. The alarm is triggered after the Hood has been in operation for 100 working hours.
(Reset see the parag. Maintenance)
Flashing When this is activated, it signals the Activated Charcoal Filter saturation alarm, indicating that
the filter must be changed; the Metal Grease Filters must also be washed. The Activated
Charcoal Filter saturation alarm comes into operation after the Hood has been working for
200 hours.