Faber GV60TT/10, User Manual

Page: 9 / 12

User manual GV60TT/10
8 < < < <
4.3 Temperature/clock setting (standard
°C/24hours)
The alteration of the temperature indication on the
display screen from °C/24hours to °F/12hours and
the other way around is done in the following
manner:

Press the OFF-key and the -key (small
flame) simultaneously until the indication
is modified (fig. 1.5).
5 Basic functions remote control
5.1 Switching on the fire

Press the OFF- key and the -key
simultaneously, until a sound signal is
audible (fig. 1.7).

The start-up procedure will be executed
now. During this period the receiver will
emit a repetitive sound signal.

The fire will start burning at the highest
position automatically now.
5.2 Adjusting the flame height

By twice in rapid succession pressing the
big flame button, will set the fire to the
highest position.

Keep the -key pushed in to increase the
flame height step by step. (fig. 1.9)

By twice in rapid succession pressing the
small flame button will set the fire to the
lowest position.

Keep the -key pushed in to lower the
flame height step by step and/or to switch
back to the pilot light. (fig. 2.0)
5.3 Switching off the fire

Pressing the OFF-key will switch the fire
completely off (fig. 1.7).
6 Only for appliances equipped with a step
burner
6.1 Operating the step burner

Please note!
The step burner will not operate for 45
seconds after the start-up procedure.

Press the SET and the -key (small flame)
simultaneously and the flame picture will
concentrate in the middle of the burner.
(fig. 2.1).

For adjusting the flame height, see section
5.2.

Press the SET and the -key (large flame)
simultaneously and the flame picture will
divide over the complete length of the
burner. (fig. 2.0) the AUX symbol appears
in the display

For adjusting the flame height, see section
5.2.
6.2 Thermostat and timer function
The following settings are possible in the
thermostat function:

Day temperature (

TEMP)

Night temperature (

TEMP)
If the thermostat function is used, the remote
control unit should be placed in the wall bracket
(fig. 2.4/2.5/2.6), this should be mounted within 4
metres of the fireplace in the same room.
The timer function (TIMER) can make the
thermostat function once or twice on day
temperature and one or twice on night
temperature during a period of 24 hours.
Factory settings thermostat and timer:
Day temperature 23°
Night temperature (appliance doesn’t switch on)
Timer P1

6:00 (getting up)
P1

8:00 (departure)
P2

16:00 (homecoming)
P2

22:00 (night)
Example setting one switch period:
Day temperature
21°
Night temperature (appliance doesn’t
switch on)
Timer P1

8:00 (getting up)
P1

22:00 (night)
7 Additional functions
The display screen on the remote control unit
always shows one of the functions below:

Please note!
By pressing the the SET-key (fig. 1.5) briefly,
the various functions can be shown
consecutively.
MAN


TEMP


TEMP

TIMER