8
NOTE
Please be sure to use the accessories provided by our company to install this electric
water heater. This electric water heater can not be hung on the support until it has been
confirmed to be firm and reliable. Otherwise, the electric water heater may drop off from
the wall, resulting in damage of the heater, even serious accidents of injury. When
determining the locations of the bolt holes, it shall be ensured that there is a clearance
not less than 0.2m on the right side of the electric heater, to convenient the maintenance
of the heater, if necessary.
4.1 Operating Of The Unit
4. METHODS OF USING
NOTE
During normal operation, the inlet valve shall be always kept open.
1
2 3
4
First, open any one of the outlet valves at the outlet of the water heater, then, open the inlet
valve. The water heater gets filled with water. When water flows out of the outlet pipe it implies
that the heater has been filled fully with water, and the outlet valve can be closed.
Insert the supply plug into the supply socket, the two indicator lights will light up this time.
The thermostat will automatically control the temperature. When the water temperature inside
the heater has reached the set temperature, it will switch off automatically, when the water
temperature falls below the set point the heater will be turned on automatically to restore the
heating.
●
●
●
①
②
③
“ON/OFF” knob, to turn on or turn off the water heater
.
“Heating indicator ” light, when the water is heated to the set temperature. The indicator light
is off, the water heater will be in a state of insulation.
“ON/OFF indicator” light, plug in the power, switch is turned to the ON position, the power
indicator light will light ON reservation.
④
“Thermostat” knob, rotate the thermostat knob to set the temperature. Maximum set
temperature is 75
℃
. Then the heating indicator light on
.
