Faber Flexa NG Glass Lux WH A60, User Manual

Page: 4 / 155

3
1. SAFETY INFORMATION
For your safety and correct
operation of the appliance,
read this manual carefully be-
fore installation and use. Al-
ways keep these instructions
with the appliance even if you
move or sell it. Users must
fully know the operation and
safety features of the appli-
ance.
The wire connection has to
be done by specialized
technician.
• The manufacturer will not be
held liable for any damages
resulting from incorrect or
improper installation.
• The minimum safety distance
between the cooker top and
the extractor hood is 650 mm
(some models can be installed
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
• If the instructions for installa-
tion for the gas hob specify a
greater distance, this must be
respected.
• Check that the mains voltage
corresponds to that indicated
on the rating plate fixed to the
inside of the hood.
• Means for disconnection must
be incorporated in the fixed
wiring in accordance with the
wiring rules.
• For Class I appliances, check
that the domestic power
supply guarantees adequate
earthing.
• Connect the extractor to the
exhaust flue through a pipe of
minimum diameter 120 mm.
The route of the flue must be
as short as possible.
• Regulations concerning the
discharge of air have to be
fulfilled.
• Do not connect the extractor
hood to exhaust ducts carrying
combustion fumes (boilers,
fireplaces, etc.).
• If the extractor is used in con-
junction with non-electrical
appliances (e.g. gas burn-
ing appliances), a sufficient
degree of aeration must be
guaranteed in the room in or-
der to prevent the backflow of
exhaust gas. When the cooker
hood is used in conjunction
with appliances supplied with
energy other than electric,
the negative pressure in the
room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by
the cooker hood.
• The air must not be discharged
into a flue that is used for ex -
hausting fumes from applianc-
es burning gas or other fuels.
• If the supply cord is damaged,
it must be replaced from the
manufacturer or its service
agent.
• Connect the plug to a socket
EN