USE ( SPEED ADJUSTMENT )
Installation Way II :
1. Drill 4 holes of diameter 5mm and diameter 130mm at the bottom of the hanging cupboard.
2. Fix air outlet into the vent on top of the hood.
3. Open filters, keep the hood in line, insert screws and swelling rubber plug, tighten the screws.
4. Fix filters.
1. Push stop button, and the motor will stop.
2. Push the low button, the buzzer will buzz once, and the motor runs at low speed.
3. Push the mid button, the buzzer will buzz once, and the motor runs at mid speed.
4. Push the high button, the buzzer will buzz once, and the motor runs at high speed.
5. Push the light button and the lights will come on. Push it again and the light will turn off.
Push Button
GENERAL USAGE AND SAFETY GUIDELINES
255 mm
514 mm
33 mm
257 mm
USE (Speed Adjustment)
Push button
1. Push Stop button,and the motor will stop.
2. Push the Low button,the buzzer will buzz once,and the motor runs at low speed.
3. Push the Mid button,the buzzer will buzz once, and the motor runs at mid speed.
4. Push the High button,the buzzer will buzz once, and the motor runs at high speed.
5. Push the light button and the lights will come on. Push it again and the light will turn off.
Charcoal filter (to be purchased)
This filter is only used for the recirculation mode.
The filter contains an active carbon absorbing the smell being discharged. The active
carbon will be saturated after some time, hence the absorption capacity will be
shortened. This filter cannot be washed or cleaned in any other way.
When the appliance is in common use, the charcoal filter should be replaced every
2-3 months. In case of more frequent frying or deep frying, shorten this interval.
1.Remove the metal filters as shown in Fig. 1.
Fig. 2
2.Install the charcoal filter on the side of the engine .
5
