Faber e-MatriX mood 800/500 RD, Installation Manual

Page: 14 / 24

Installation manual e-MatriX mood 800/500 RD,ST
14 < < < <
Removing glass
5.1 e-MatriX mood RD
Front glass (see fig. 1.0, provide service from this
side).

Rotate both glass clamps clockwise.
See fig. 2.0a and 2.0b.

Place the suction cups and remove the
front glass. See fig. 2.0c.
For replacing the glass repeat the steps in reverse
order.
Second front glass
For cleaning only it’s not necessary to remove this
glass.

Rotate both glass clamps clockwise.
See fig. 2.2a and 2.2b.

Place the suction cups and remove the
front glass. See fig. 2.2c.
For replacing the glass repeat the steps in reverse
order.
Side glass
For cleaning only it’s not necessary to remove this
glass.

Place the suction cups and remove the
glass. See fig. 2.1.
For replacing the glass repeat the steps in reverse
order.
5.2 e-MatriX mood ST
Front glass (see fig. 1.1, provide service from this
side)

Remove the cover list. See fig. 2.3a and
2.3b.

Rotate the glass clamp clockwise.
See fig. 2.3c.

Place the suction cups and remove the
glass. See fig. 2.3d.
For replacing the glass repeat the steps in reverse
order.
Second front glass
For cleaning only it’s not necessary to remove this
glass.

Remove the cover list. See fig. 2.4a and
2.4b.

Rotate the glass clamp clockwise.
See fig. 2.4c.

Place the suction cups and remove the
glass. See fig. 2.4d.
For replacing the glass repeat the steps in reverse
order.
Decoration set

Please note!
To get the right glow effect, the (optional) bot-
tom lighting must be switched on at 100% in-
tensity.
Make sure the ITC-V2 App is connected to the fire,
see fig. 7.0.

Switch on the glow effect, see fig. 7.1.

Click on the “flame” in the circle, see fig.
7.1.

Click on the “settings”, see fig. 7.2.

Set “bottom lighting” to maximum, see
fig. 7.3.
6.1 Log set
See the included decoration instruction card or
Chapter 11:

Please note!
Placing the logs is a meticulous job, this deter-
mines the flame distribution.
Do not let any decoration material fall into
the outflow (fire) opening.
The outflow openings may not be completely
covered.

Divide the mini chips over the bottom.

Place the first two logs over the middle
section in the recesses provided for this.

Place the remaining logs.

Apply the ash material.
Fine tuning of the glow bed
By placing the decoration chips close together you
create a real glow bed.
6.2 Pebbles/Acrylic ice
Spread an even amount of Pebbles or Acrylic-ice on
the bottom plate.