Faber e-MatriX 800-500 I, Installation Manual

Page: 11 / 44

Installation manual MatriX 800/500 I,II,III and 800/650 I,II,III
11 < < < <
Ventilation
Correct ventilation prevents damaging overheating
of the gas control block and its electronics and also
limits the temperature of the convection air. Use
the supplied Faber ventilation grids (article number
A9296400) or a similar alternative with a minimum
free passage of 200cm² per grid, in the space
above the fire, when building the false chimney.
Within the false chimney, an horizontal screen
plate, made of non-combustible material, must be
installed just above the ventilation openings. (see
“A” in fig. 1.1 for the 800 I, fig. 1.3 for the 800 II
and fig. 1.5 for the 800 III version).
Installation and finishing

Please note!

Take into account a minimum distance of
2mm due to expansion of the fireplace.
See fig. 2.7.

Take into account the thickness of any
finishing layer!
Method I: installation WITH cover strip (fig. 2.1)
The following points are of interest (fig. 2.2 and
2.3):
I = built-in frame
J = distance profiles

Built the false chimney against the built-in
frame “I” and distance profiles “J”.

Do not built the false chimney
(underneath the appliance) higher than
the top of the distance profile “J”
(fig. 2.3).
Method II: installation WITHOUT cover strip
(fig. 2.4)

Please note!
At the MatriX front glass only versions, the
cover strip is fixed by screws, remove those
first! (fig. 2.5).
The following points are of interest (fig. 2.6):
K = built-in frame
L = distance profiles
M = glass supports
N = top edge of the combustion chamber

Remove all distance profiles “L”.

Please note!
Make sure that the screws of the front
distance profile “L” will be replaced, in order
to ensure the air tightness of the appliance.

For the height of the plateau, see point
“N” (fig. 2.6 and 2.7).

Take into account a minimum distance of
2mm between plateau and glass support
“M” due to expansion of the fireplace.
(fig. 2.7).
5 Removing glass
5.1 Front glass
MatriX I:

Disassemble cover strip “A” on both sides
(fig. 3.0).

Rotate clamp “B” clockwise on both sides
(fig. 3.0).

Place the suction cups on the glass, slide
frame “C” upwards and disassemble the
front glass (fig. 3.1).
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
MatriX II:

Disassemble cover strip “A” (fig. 3.0).

Rotate clamp “B” clockwise (fig. 3.0).

Place the suction cups on the glass and
slide frame “C” upwards (fig. 3.2).

Disassemble the front glass (fig. 3.3).
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
MatriX III:

Place the suction cups on the glass and
slide frame “C” upwards (fig. 3.4).

Disassemble the front glass (fig. 3.5).
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.