Faber CHLOE XL CG MATT A110, Manual, Page: 3 / 96

3
Recommendations
and suggestions
• The Instructions for Use apply
to several versions of this ap-
pliance. Accordingly, you may
Ýpf" fguetkrvkqpu" qh" kpfkxkfwcn"
features that do not apply to
{qwt" urgekÝe" crrnkcpeg0
• The manufacturer will not be
held liable for any damages
resulting from incorrect or im-
proper installation.
• The minimum safety distance
between the cooker top and
the extractor hood is 650 mm
(some models can be installed
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
• Check that the mains voltage
corresponds to that indicated
qp"vjg"tcvkpi"rncvg"Ýzgf"vq"vjg"
inside of the hood.
• For Class I appliances, check
that the domestic power supply
guarantees adequate earthing.
Connect the extractor to the
gzjcwuv" Þwg" vjtqwij" c" rkrg" qh"
minimum diameter 120 mm.
Vjg" tqwvg" qh" vjg" Þwg" owuv" dg"
as short as possible.
• Do not connect the extractor
hood to exhaust ducts carry-
ing combustion fumes (boilers,
Ýtgrncegu." gve0+0
• If the extractor is used in
conjunction with non-electrical
appliances (e.g. gas burning
crr."c"uwhÝekgpv"fgitgg"
of aeration must be guaranteed
in the room in order to prevent
vjg"dcemÞqy"qh"gzjcwuv"icu0"Vjg"
kitchen must have an opening
communicating directly with the
open air in order to guarantee
the entry of clean air. When
the cooker hood is used in
conjunction with appliances
supplied with energy other than
electric, the negative pressure in
the room must not exceed 0,04
mbar to prevent fumes being
drawn back into the room by
the cooker hood.
• The air must not be discharged
kpvq" c" Þwg" vjcv" ku" wugf" hqt" gz
-
hausting fumes from appliances
burning gas or other fuels (not
applicable to appliances that
only discharge the air back into
the room).
• In the event of damage to the
power cable, it must be replaced
by the manufacturer or by the
technical service department, in
order to prevent any risks.
• If the instructions for installation
for the gas hob specify a greater
fkuvcpeg" urgekÝgf" cdqxg." vjku"
has to be taken into account.
Regulations concerning the dis-
ejctig"qh"ckt"jcxg"vq"dg"hwnÝnngf0
• Use only screws and small parts
in support of the hood.
Warning: Failure to install the
uetgyu" qt" Ýzkpi" fgxkeg" kp" ce
-
cordance with these instructions
may result in electrical hazards.
• Connect the hood to the mains
through a two-pole switch having
a contact gap of at least 3 mm.
Use
• The extractor hood has been de-
signed exclusively for domestic
EN