UK/IRL
45
UK/IRL
44
10.4.3 Setting the right transmission code
The receiver has to learn the code from the transmitter, which is
already done at the factory. However the code disappears if the
receiver is disconnected from the mains for a longer period, or when
you using the transmitter for more then 15 times out of the range of
the receiver (then the code doesn’t match the code in the receiver).
1.
Push the "mod" button on the receiver and hold it for 3 seconds.
2. The green control lamp will light up and stay on. Repeat this step
if not.
3. Push a button on the remote control. The control lamp on the
receiver should now go out.
4. Again push a button on the remote control. The lamp starts
flashing and will switch off eventually.
5. The receiver now recognizes the remote control. The remote
control now functions.
6. Check if you can hear a sound and the motor runs, when you
push a button on the remote control. (If not so please check the
batteries).
10.4.4 Changing the batteries
There is no risk of electric shock as the low voltage supply is similar
to that used in torches. Always turn off the appliance before changing
batteries.
R
Re
ecce
eiiv
ve
err iiff a
ap
pp
plliicca
ab
blle
e
1.
Open the door or the ashtray on the front side of the appliance.
You will find the receiver, placed in a holder.
2. Take the receiver out the holder. (If necessary remove the two
connectors from the control valve).
10.4.1 To light
1.
Push in and turn the control knob (A) from
{
anticlockwise to
the setting
(small flame). You will hear a ignition click. Check
that the pilot is lit (if not repeat).
2. Continue to hold in the control knob for a further ten seconds to
ensure that the pilot flame is stable.
3. Release the knob. The pilot should remain alight.
4. Turn the control knob A to the
position.
5. Set the on/off switch on the receiver to "on”.
low flame
high flame
6. Use
(high) and
(low) to achieve the desired heating and
flame effect.
7. You will hear a beep every time the receiver recognises a good
signal. (If not, so see 10.4.3, setting the right transmission code).
8. When the fire is not be used for a prolonged period, turn off the
pilot (see 10.4.2).
10.4.2 To extinguish
1. Push
(low) till the burner goes out and you can hear the motor
clicking.
2. To enable the remote control turn knob A to the
position.
3. To extinguish the pilot turn control knob A to position
{
, although
it is in order to leave the pilot permanently lit.
fig. 20
remote control
