MAP2 / MAP2L
CLG-SL
FABER-COM srl - Via Romana 36/1 - 42028 Poviglio (RE) - Italy Tel. +39-0522-960428 Fax. +39-0522-969644 - www.fabercom.it
\Prodotti\Limitatore CLG\PCLG-LxE[CLG-SL- Barra LED]\Documenti\SM#Limitatore CLG-SL_v102 - 19/04/2017
COM
FABER -
PRG2-DEC
NEXT
NEXT
PREV
PREV
COM
FABER -
RS-232 Adapter
CLG
Serial cable
Ordering code:
PISPM
programming
connector
Page 4 / 6
Setting parameters by final user
Hardware key to increase the load limit threshold
The load limiter's thresholds are programmed using an external, little, 4 buttons,
keyboard. The keyboard is an optional. Its name is "PRG-CLG". When it is
connected the green led blinks four times in a second.
The PRG2 (either CLG version or DEC version) can be used even to increase
the load limit threshold up to 125%, for a brief period of time.
In order to increase the limit: when you connect the PRG2, the "+" button has to
be pressed within 5 seconds then kept pressed till the green led blinking will
becomes slower.
In most cases, CLG load limiter doesn't need to be connected to PC:
- thresholds are programmed by means of PRG 2 keyboard
- fault analysis is done by means of the green LED placed near connector
It is possible to connect CLG card to PC with serial port using the special serial adapter AISM (code: PISPM) and
free SepSim Windows® program.
PC connection is required in the following cases:
- to set whole the load limiter's parameters
- upload/download the working configuration
- to monitor some working parameters when fault occurs
- to update the firmware
PC connection
