Installation Instructions
VI-COWL
Product Number: VC2900
2010 - 2018 DODGE 2500
Copyright 2009 Fab Fours, Inc
. Page 11 of 19
VC2900_Installation_Manual_REV_A
Note: Both driver side and passenger side brackets install the same way.
Fig 8
a.
Position the driver side bracket as pictured in
Fig 8
.
b.
Loosely install the two factory bolts as shown in
Fig 8
item
(1)
.
c.
Install the outer 5/16”-18 zinc bolt, zinc lock washer and zinc flat washer.
d.
Fully tighten down the 5/16”-18 bolt.
e.
Repeat the same procedure for the passenger side bracket.
Caution
: The Fab Fours VC2900 brackets contain the same adjustability as the
OEM counterparts. This may lead to wiper interferences with the ViCowl arms if
the brackets are set too low or rotated to far to the windshield. Be sure to check for
wiper clearance after the arms are fully tightened at the top bracket hole but before
and Riv-Nuts are marked and drilled into the factory fenders. Push driver side arm
tight to fender at Riv-Nut location and turn on wipers to check. Some readjustment
of the hood brackets may be necessary followed by hood realignment.
Note: do not fully tighten down the two factory bolts on the lower bracket yet, these
bolts will be tightened down after the hood has been reinstalled and final
adjustments have been made.
(1) Reuse OEM
hardware in both
places here.
(2) Install using the
provided 5/16”-18
hardware.
