Installation Instructions
Ford Replacement Bumper
Product Number: S2560
Application: ’11-Current Ford Super Duty
Copyright 2010 Fab Fours, Inc.
Page 5 of 9
S2550 Rev D_Rev C
IV.
Bumper Installation
NOTE: The Following Installation steps apply to the installation of the
Bumper to the vehicle. PLEASE READ THE ENTIRE MANUAL
BEFORE ATEMPTING INSTALLATION! Ignoring these steps will
increase your probability of scratching the vehicle during product
Installation!
1.
Remove the Bumper from the shipping carton. Lay all items out on a blanket
to prevent damage to the powder coating. Install lower guard
(IF
INSTALLING A WINCH SEE WINCH TRAY INSTALLATION
INSTRUCTIONS)
by rotating it into position from the bottom of the bumper
as shown below. Install three ½” fasteners (Provided in hardware bag labeled
20260-HW) per side with bolt heads facing the inside of the bumper.
Figure 4 - Lower Guard Installation
2.
OPTIONAL:
If you wish to retain the stock fog lamps, remove the lights from
the stock bumper and reinstall using OEM plastic push rivets and adjuster
screw in the provided brackets behind the protective mesh.
