FAAC TM2 PP M, Manual

Page: 12 / 44

TM2 PP M 12 A4516_6G38_Rev.A
I
KEY TO SYMBOLS
UP DOWN
Pre s s t h e
UP-button
Press the buttons quickly according to the sequence indicated.
Press the
DOWN-button
DOWN DOWN UP
DOWN
UP
COMAND SEQUENCES EXAMPLE
UP UP UP
Most of the command sequences have three or six distinct steps.
The buttons must be pressed for less than 0.5 seconds as shown in the sequence,
without taking more than 1 second between one step and the next. If more than 1
second is taken, the command is not accepted and the sequence must be repeated.
Command sequence example:
Attention! If the sequence requires a repetition
of the same commands (Up+Up/ Down+Down),
an interposition of the Stop position could be
necessary depending on the type of switch in use.
INSTRUCTION FOR USE
The tubular motor is very simple to be used and installed, it does not need any
regulation as it automatically detects the position of limit switch.
The rolling shutter must be equipped with:
A - security locks or stiff fixing springs,
B - fixed or removable stoppers for end slats.
It is very important to check the sturdiness of the
rolling shutter.
Execute a complete cycle of opening and closing
before using the manual override device.
Note: After manual override, the motor resets the proper positions upon reaching
a valid limit switch position.
A
B
EN