FAAC T-MODE TM 45 R 15/17, Manual, Page: 6 / 10

P
P
ENGLISH
6
4 MEMORY STORING THE FIRST RADIO 433Mhz
UP
DOWN
STOP
PROGRAMMING
PUSH-BUTTON
Fig.8
REAR
VIEW
Portable remote control
Wall-mounted remote control
CHANGE RADIO
CHANNEL
ENABLE
DISABLE
SUN SENSOR
MAX. 20 RADIO DEVICES CAN BE STORED IN THE MEMORY OF THE MOTOR INTERNAL RECEIVER (WALL-MOUNTED REMOTE CONTROLS,
RADIO ANEMOMETERS, ETC.). MEMORY STORING CAN OCCUR IN ANY MOTOR STATUS.
According to the configuration of your installation
(Fig.9) observe the instructions given in the following
paragraphs.
1. Supply the motor with power.
2. Within 15 seconds press the P programming push-button,
then the DOWN push-button of the transmitter.
3. The motor performs two brief movements in both directions
to confirm the correct programming. Perform some brief
up, stop and down movements to check if the operation
is correct.
TYPE 1 and 4
TYPE 2 and 3
1. Supply the motor with power.
2. Within 15 seconds press the P programming push-button,
then the UP push-button of the transmitter.
3. The motor performs two brief movements in both directions
to confirm the correct programming
4. Perform some brief up, stop and down movements to check
if the operation is correct.
TYPE 1
TYPE 2
TYPE 3
TYPE 4
MOTOR HEAD SIDE
Fig.9