70
480
9
480
70
22
22
4
3
5
1
1
49
ENGLISH
4
3 DIMENSIONS
4 ELECTRICAL PREPARATIONS
Fig.2
Fig.4
5.2 WALLING IN THE BEARING CASE
These are the possible work conditions:
a) Existing gate with fixed hinges.
b) Existing gate with adjustable hinges.
c) Gate to be made.
5 INSTALLING THE AUTOMATED SYSTEM
5.1 PRELIMINARY CHECKS
To ensure a correctly operating automated system, the structure
of the existing gate or gate to be built must satisfy the following
requirements:
1) Individual leaves must not weight more than 800 kg.
2) Maximum length of single gate: 2 mt CBAC, 4 mt SB
3) A strong and rigid leaf structure.
4) Smooth, uniform gate movement, without any irregular friction
during the entire travel.
5) Distance “A” between lower edge of gate and ground as
shown in Fig.
7
.
6) The distance between the gate leaves - in the opening and
closing positions - and the existing structures, must respect
current legal regulations
We advise you to carry out the metalwork jobs before installing
the automated system.
The condition of the structure directly influences the reliability and
safety of the automated system.
3.1 STANDARD VERSION
TECHNICAL
SPECIFICATIONS
CBAC
OPERATOR
SB
OPERATOR
Power supply (V dc)
24
Absorbed power (W)
60 (*)
Protection class
IP 67
Type of oil
FAAC HP OIL
Operating ambient temperature
-20° C +55°C
Rated Operating Time (R.O.T.)
Continous duty at 55°C
Hydraulic shut-down facility
Supplied
Not supplied
Pump flow-rate (lpm)
0.36
Max. torque (Nm)
**
500 (E700) ; 600 (E124)
Angular speed (°/sec) ***
5.5 (E700) ; 8.2 (E124)
Max opening angle ****
113° (S700H 100°)
187° (S700H 180°)
Leaf max. length (m)
2
4
Leaf max. weight (Kg)
800
2 TECHNICAL SPECIFICATIONS
NOTE: ALL MEASUREMENTS IN MILLIMETRES.
TO ENSURE CORRECT INSTALLATION, THE LEAF ROTATION
AXIS MUST BE PERFECTLY ALIGNED WITH THE OPERATOR
(Fig. 7)
Fig.3
3.2
VERSION WITH MECHANICAL RELEASE
* EACH INDIVIDUAL OPERATOR
** CONSIDERING 55 Bar OF STATIC PRESSURE IN THE CHAMBERS
*** CONSIDERING A PUMP CAPACITY OF 0.6 Ipm
**** ° OF TRAVEL ARE LOST WHILE THE OPERATOR IS BEING
INSTALLED
a
S700H Operators with encoder
2x2.5 mm ² / AVG 12 for motor (minimum)
2x0.5 mm ² / AVG 20 for encoder bus
b
Bus 2 Easy Photocells
2x0.5 mm ² / AVG 20
c
Control unit
(To be selected according to the installed power supply)
2x2.5 mm ² / AVG 12 for powering
d
Key operated push-button
2x0.5 mm ² / AVG 20
e
Flashing lamp 24 V
2x1.5 mm ² / AVG 16
0 V ~ / 50 Hz
or
5 v ~ / 60Hz
(According to
the selected
control unit)
To avoid excessive voltage drops, we recom-
mend that the length of the motor cables with
a section of 2.5 mm, should not exceed 20 m.
The maximum total length of the BUS cables must not
exceed 100 m.
