FAAC E045S, User Manual

Page: 26 / 32

E045S 24 532373 - Rev.A
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
10.1 FIRMWARE VERSION
The firmware version is show on the display for 5
seconds each time it is switched on.
10.2 CHECKING THE MOVEMENT
Access basic programming and use function
M2
for
Leaf2 (displayed if the automation is configured for 2
leaves) and function
M1
for Leaf1.
1. The function displays
--
.
2. Use buttons
++
and
--
in dead man mode. One of
the expected commands must be given:
++
to OPEN (
oP
on the display)
--
to CLOSE (
cL
on the display)
Otherwise, temporarily disconnect the power supply
and invert the phases (OP/CL) of the motor.
10.3 AUTOMATED SYSTEM STATUS
The display, other than in the programming menu,
provides information regarding the status of the
automation system:
 8
Automated system status
00
CLOSED
06
CLOSING
01
OPEN
07
FAILSAFE IN PROGRESS
02
STATIONARY THEN OPENS
08
CHECK Bus 2easy
03
STATIONARY THEN CLOSES
09
PREFLASHING BEFORE OPEN-
ING
04
IN PAUSE
10
PREFLASHING BEFORE CLOS-
ING
05
OPENING
10.4 LEDS CHECK
 9
bold indicates the condition of the LEDs with the
board powered, the gate at its halfway position and no
connected device active (

=on ;

=off).
 9
Status of the LEDs
LED colour meaning
 
OPEN A red
Total motion command active
not active
OPEN B red Partial motion command active not active
STOP red
Stop command
not active
active
5V blue Power supply 5 V on off
24V blue Accessories power supply 24 V
"
on off
BUS red Bus 2easy devices
see § Bus 2easy devices
BUS MON green Bus 2easy devices
USB red USB pen drive inserted (*) Installed not inserted
RADIO1 red Channel 2 Omnidec (*) active not active
RADIO2 red
Channel 2 Omnidec (*) active
not active
(*) Additional LED status or meanings are shown in the section on the accessory to which it refers.
LED colour meaning
  
ERROR red
Error/alarm signalling alarm in progress error in progress
not active
10. DIAGNOSTICS