FAAC DAAB DB411, Instruction Manual, Page: 2 / 12

2
DAAB RADIO CARD DB411 INSTRUCTION MANUAL
Revision 7
Technical data
Dimensions (WxHxD) 45 x 50 x 30
Temperature range 0 - 45 0C
Indications 5x LEDs
Outputs 4 internal signals
Number of transmitters/buttons Max 85
Operating frequency
433.92 MHz
Degree of protection Internal installation
Compatibility The radio receiver is compatible with the DBR1 transmitter
Description
DB411 is an add-in card to the automatic control units EP104 and EP105. There is a button on both the radio receiver
module and on the base card for programming hand transmitters. These buttons have the same function and are used to put
the receiver into programming mode and to choose which of the receiver’s 4 outputs is to be programmed. The illustration
below shows where the button is to be found on the receiver.
• DB411
Installation of DB411
1. Discharge any static charge in your body by touching an earthed connection before starting installation.
2. Disconnect the power to the automatic control unit.
3. Screw the DB411 circuit board into place on the spacers on the automatic control unit using two M3x5 screws.
4. Restore the power supply to the automatic control unit.
The illustration shows the location of the spacers on the EP104
Button for programming SW1
LED indication D1