FAAC B614, Instruction Manual

Page: 51 / 68

 4 8
B614 49 732998 - Rev.A
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
8. 8.
13 5
12
11
1
2
14 7 6 8
10 3 4 9
no
No device registered
cc
BUS 2easy line short-circuited
Er
BUS 2easy line error
RECTANGULAR BEAM LIGHT KIT
Follow the assembly instructions provided with the
product respecting all the safety precautions indicated
in this manual.
9.5 ROUND BEAM LIGHT KIT
Follow the assembly instructions provided with the
product respecting all the safety precautions indicated
in this manual.
9.6 INTEGRATED FLASHING LIGHT
1. Open the upper cover.
2. Fasten the flashing light with the screws provided
(
 4 8
).
3. Connect the flashing light to terminal J21.
4. Set the operating mode (
oS
in Advanced pro-
gramming).
5. Close the upper cover.
6. Check that the device is working properly.
9.7 BEAM JOINT KIT
Follow the assembly instructions provided with the
product respecting all the safety precautions indicated
in this manual.
!
The installation of a jointed beam must take the
specific risks into consideration:
- IMPACT on the horizontal section of the beam,
when the beam is open
- CRUSHING in the jointed area, when the beam
is moving.
- Do not use joint to limit the height of the vehicles
passing.
- Indicate the maximum height of the vehicles consi-
dering the height of the beam itself.
- Apply a danger of crushing sticker on the beam in
the jointed area.
- Check the integrity of the wire during the half-yearly
scheduled maintenance.