AT-4
FAAC S.p.A. Via Calari, 10
– 40069 – Zola Predosa (BO) - Italy
Page 8 of 25
3.2 CONNECTIONS
The cables inside the AT-4 are connected by means of connectors with
spring terminals which make for an easy and intuitive use.
1. Remove the sheath from the cable for approx.
9 mm (
0.35 inch
).
2. Using a screwdriver push downward to free
the cable passage. Use a screwdriver with
thin flat bit.
3. Fit the cable into the connector terminal.
4. When the screwdriver is removed, the cable
remains blocked thanks to the spring
connector.
5. Check if the cable is correctly fixed by drawing
it gently.
cable
screwdriver
Fig.7
Note 1: One cable only for each terminal.
Note 2: Usually there is no need to use pins. However, if this is necessary,
you can use them provided that they are correctly crimped.
See Appendix A for the recommended cable section.
